[Elecraft] Installing Sub Receiver

[Vic Rosenthal]

Take off the left side panel and use a flashlight to illuminate the connectors.

Vic 4X6GP/K2VCO 

> On May 9, 2015, at 2:29 AM, K5HM <k5hm.ron at gmail.com> wrote:
> 
> I am down to the part where I put the Sub receiver enclosure into the K3 and
> mate with the pins connecting the Subin and Subout boards to the enclosure.
> But - Once I set it in the rig, I can't see if the pins on these connectors
> are properly aligned.  There is not a good viewing angle  It looks ok but I
> could be off to one side by a pin or two or miss the connector altogether.
> The long screws that pass all the way through the enclosure,  mate up with
> the standoff on the main receiver board. 
> 
> Any way to know if I did it right before I complete the installation and
> plug it in?   
> 
> 73,
> Ron, K5HM
> k5hm.ron at gmail.com
> www.qrz.com/db/k5hm
> 
>         Excelsior!