[Elecraft] Installing Sub Receiver

[Matt Zilmer]

I removed the left side panel to verify SubRX pin alignment.  There
may be other opinions on this too.

73,
matt
W6NIA

On Fri, 8 May 2015 18:29:34 -0500, you wrote:

>I am down to the part where I put the Sub receiver enclosure into the K3 and
>mate with the pins connecting the Subin and Subout boards to the enclosure.
>But - Once I set it in the rig, I can't see if the pins on these connectors
>are properly aligned.  There is not a good viewing angle  It looks ok but I
>could be off to one side by a pin or two or miss the connector altogether.
>The long screws that pass all the way through the enclosure,  mate up with
>the standoff on the main receiver board. 
>
>Any way to know if I did it right before I complete the installation and
>plug it in?   
>
>73,
>Ron, K5HM
>k5hm.ron at gmail.com
>www.qrz.com/db/k5hm
>
>        Excelsior!
>
>
>______________________________________________________________
>Elecraft mailing list
>Home: http://mailman.qth.net/mailman/listinfo/elecraft
>Help: http://mailman.qth.net/mmfaq.htm
>Post: mailto:Elecraft at mailman.qth.net
>
>This list hosted by: http://www.qsl.net
>Please help support this email list: http://www.qsl.net/donate.html
>Message delivered to mzilmer at roadrunner.com
Matt Zilmer, W6NIA
--
"Always store beer in a dark place."  -R. Heinlein