[Elecraft] K3 errata for the new synthesizer

[Guy Olinger K2AV]

Such reading of errata would be a danger in anyone's manual correction.
Unless a page specifically says "replace page X in its entirety with this
page" then the original page must be read with an eye toward insertion,
deletion or replacement based on the errata

Of course I was told this in multiple educational settings without
listening, and only actually learned when confronted with a resultant
miswire and traced back to the source of my misinformation.

We are so lucky with Elecraft to actually get fixes and revisions. In so
many other places you have to buy a new model. Even half-baked errata is a
huge improvement over those companies.

73 Guy

On Friday, May 1, 2015, Randy Moore <wrmoore47 at gmail.com> wrote:

> On a third look, I see why I missed this. The instructions in the Assembly
> Manual do say to turn on Tech MD. However, when I initially went through
> the errata, I took the Page 70 note to replace all of the Synth. Cal.
> instructions in the manual, so when I got there during assembly, I just
> read the errata note and ignored the manual. I still think at least a note
> about turning on TECH MD would be good in the errata note.
>
> Randy, KS4L
>
> > On May 1, 2015, at 10:54 AM, dwines <dwines at suddenlink.net
> <javascript:;>> wrote:
> >
> > I believe the instructions say to turn on Tech Mode before checking SYNn.
> >
> > Don, K5DW
> >
> >
> > Sent via the Samsung GALAXY S® 5, an AT&T 4G LTE smartphone
> >
> >
> > -------- Original message --------
> > From: Randy Moore <wrmoore47 at gmail.com <javascript:;>>
> > Date:05/01/2015 6:36 AM (GMT-06:00)
> > To: K3support at elecraft.com <javascript:;>, Elecraft Discussion List <
> elecraft at mailman.qth.net <javascript:;>>
> > Subject: [Elecraft] K3 errata for the new synthesizer
> >
> > In building K3 #8999, I believe I discovered an omission from the errata
> > sheet, having to do with the new synthesizer board.
> >
> > In the errata for "Page 70, Synthesizer Calibration," I believe the
> > display of "SYN1 OK" and "SYN2*FF" in the VFO B area of the LCD is
> > dependent on having TECH MD turned on in the CONFIG MENU.  At least it
> > is on #8999 with firmware 5.14.
> >
> > 73,
> > Randy, KS4L
> > ______________________________________________________________
> > Elecraft mailing list
> > Home: http://mailman.qth.net/mailman/listinfo/elecraft
> > Help: http://mailman.qth.net/mmfaq.htm
> > Post: mailto:Elecraft at mailman.qth.net <javascript:;>
> >
> > This list hosted by: http://www.qsl.net
> > Please help support this email list: http://www.qsl.net/donate.html
> > Message delivered to dwines at suddenlink.net <javascript:;>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net <javascript:;>
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to k2av.guy at gmail.com <javascript:;>



-- 
Sent via Gmail Mobile on my iPhone