[Elecraft] [K2] voltage/current sensing K2 SN 4277

[Bill Frantz]

FWIW, I just found a 2mm long piece of wire clipped from a 
component lead shorting my current project. Look carefully.

73 Bill AE6JV

On 3/26/15 at 3:16 PM, w3fpr at embarqmail.com (Don Wilhelm) wrote:

>You did not say what your "poking around inside" consisted of.  
>If you induced static charge on some of the pins of U6 that 
>could be the cause - OTOH, if you were soldering, look for 
>solder in places where it should not be (solder bridge).

-------------------------------------------------------------------------
Bill Frantz        | Re: Hardware Management Modes: | Periwinkle
(408)356-8506      | If there's a mode, there's a   | 16345 
Englewood Ave
www.pwpconsult.com | failure mode. - Jerry Leichter | Los Gatos, 
CA 95032