[Elecraft] K3 TX Gain failure

[Mike Reublin NF4L]

The 5W TX cal fails also, but no error message on the K3.

> On Mar 24, 2015, at 11:41, Mike Reublin NF4L <nf4l at comcast.net> wrote:
> 
> I just loaded 5.14 firmware, and ran the 50W TX gain calibration. It fails, the K3 displays ERR TXG. The book says band-pass or low-pass filters out of whack.
> 
> What's my remedy?
> 
> 73, Mike NF4L 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to nf4l at comcast.net