[Elecraft] Mic gain goes to zero using N1MM

[Don Wilhelm]

Jerry,

Does the K3 respond normally when operated from the buttons and knobs?
If so, the problem lies with the software that you are using - in this 
case, N1MM - unless there is a bug in the K3 command structure, and 
AFAIK there have been no recent changes.

73,
Don W3FPR

On 3/20/2015 9:00 PM, Jerry Knowlton wrote:
> Evening all,
>
> I was setting up N1MM with the K3 for the Virginia QSO party tomorrow when I
> noticed the following strange behavior.
>
> Whenever I press any of the FKeys on N1mm (with the exception of F4 and
> F12), the mic gain on the K3 gets set to 1. I cannot remember this was
> always this way or something has changed in either N1MM or the newer K3
> configuration files.
>
> So a couple of questions before I jump over to N1MM with a bug report; has
> anyone else experience this problem? Any suggestions to check on the K3?
>
>