[Elecraft] K2 Settings Retrieval Software

[Sverre Holm (LA3ZA)]

I just wanted to remind the list of the AB3AP software found on
http://udel.edu/~mm/ham/elecraft/

I'm especially fond of the software for "K2 Settings Retrieval" about which
he says "Save your K2 set up in case of an unexpected reset."

I have just serviced a K2 where the previous owner had had soldering
problems (untinned toroids, solder bridges, ...) as well as settings which
were far off. I find it useful then to start by reading out the settings to
figure out what the starting point is, as well as backing up all the values
when the calibration has been completed.

The AB3AP software is in the form of Java programs. My web browsers don't
allow them to be run, but simply downloading the code and running them from
the command line works fine. For a PC this is "javaws params.jnlp".



-----
Sverre, LA3ZA

K2 #2198, K3 #3391,
LA3ZA Blog: http://la3za.blogspot.com,
LA3ZA Unofficial Guide to K2 modifications: http://la3za.blogspot.com/p/la3za-unofficial-guide-to-elecraft-k2.html
--
View this message in context: http://elecraft.365791.n2.nabble.com/K2-Settings-Retrieval-Software-tp7599921.html
Sent from the Elecraft mailing list archive at Nabble.com.