[Elecraft] K3 voltage indicator

[Robin Moseley]

Measure the voltage inside the K3,   at the powerpole..   you may need 
thicker DC lead or clean the fuse contacts.

G1MHU

-----Original Message----- 
From: Harry Yingst via Elecraft
Sent: Sunday, March 08, 2015 12:47 AM
To: graham at g4fnl.co.uk ; Elecraft Reflector
Subject: Re: [Elecraft] K3 voltage indicator

What are you using for a Power Supply?


      From: G4FNL <graham at g4fnl.co.uk>
To: Elecraft Reflector <elecraft at mailman.qth.net>
Sent: Saturday, March 7, 2015 5:27 AM
Subject: [Elecraft] K3 voltage indicator

Folks

I suspect that may have been asked before, so forgive me if it has, but I
need to know what the typical voltage readings are observed (on the K3
voltage indicator) when
a) On receive?
b) With say 10w TX power?
c)  With 100W TX power?

Using a DMM, I can see that my 13.8volt linear PSU seems to drop 0.1volt
when going from receive to the 100W TX level - yet the  display indicator on
the K3 goes from 13.7v (receive) to 13.3v (10W) to 12.9v (100W) Is this
typical?

73 Graham G4FNL

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to hlyingst at yahoo.com



______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to g1mhu at hotmail.com