[Elecraft] KPA100 U6 voltage issue

John Lemay john at carltonhouse.eclipse.co.uk
Sun Jun 28 03:39:03 EDT 2015


Cathy

With several observed voltages being an order of magnitude wrong, I would
suspect the meter - or, dare I suggest,  the user !

John G4ZTR

-----Original Message-----
From: Elecraft [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of
Catherine James
Sent: 27 June 2015 19:11
To: elecraft at mailman.qth.net
Subject: [Elecraft] KPA100 U6 voltage issue

I recently began building a just-purchased KPA100 kit for my K2 #5191.  All
was well until I reached the voltage checkpoints on page 26.

U5 pin 1 is 0.8 volts (not 0 to 0.1)

U5 pin 7 is 0.9 V (not 0 to 0.1)

U6 pin 6 is 17 volts (not 0 to 0.5)


I am much more concerned about U6, but perhaps the U5 voltages give you more
information.


The no pa pa message comes up as expected, and the current indicated on the
k2 display is less than 400 ma.


The keys are in the correct places on the ribbon cable. Nothing has ever
been plugged into the DB9 port, so this is not the issue where a standard
serial cable damages the kpa100 through the aux port non-standard wiring.


The K2 appears to work fine with the partially built KPA100 disconnected.
Voltages on D9 of the K2 RF board (my proxy for V RFDET) are much lower than
17 volts (kpa100 not connected) so the high voltage appears to come from the
KPA100, not the K2.


I have the KSB2 installed, but haven't explored that its voltages, and
haven't tested whether it still works following the "17 volt incident".


I don't see any obvious solder bridges on the KPA100.


Where would voltages near 17 volts normally be found on the KPA100 board?


Thoughts on next steps?


Cathy

N5WVR

Sent from Yahoo Mail on Android

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to john at carltonhouse.eclipse.co.uk



More information about the Elecraft mailing list