[Elecraft] K3 KXV3B install problems

[Michael Eberle]

I just removed the KIO3 modules and the rear panel to avoid having to 
cut pins or bend boards.  The fan panel had to be removed to access a 
screw holding the rear panel to the KPA100 shield though.

Mike
KI0HA

On 6/16/2015 9:00 AM, NW0M wrote:
> Last night I installed the new KXV3B board into my K3.  Yes, the pins are
> just a bit long - maybe 1/16 inch.  Just long enough that the pins don't
> clear the J66 socket as stated in the installation instructions.
>
> But after several tries, I was finally able to do it without clipping the
> leads or any other modification.  With one hand, I asserted some upwards
> pressure on the BNC connectors and some slight downwards pressure on the RF
> board below.  Then with the other hand, I ran my finger along the pins and
> was able to press them so they mated to the socket.
>
> Hope this helps.
> 73, Mitch NW0M
>
>
>
>
>