[Elecraft] Question about KRX3 install

[Edward R Cole]

One combo you did not cover was with KRX3 installed and no KAT3 
installed.  That is my configuration.  I ran input to the KRX3 to the 
separate BNC.  But the KRX3 menu with ATU selected does not connect 
my KRX3 to the main ANT.  Essentially I have either "not installed" 
or BNC as choice for KRX3.

That suits my use fine.  I mainly use the KRX3 to receive the 28-MHz 
IF of my dual-receiver 144-28 transverter.  Other use might be a 
separate low-noise Rx antenna on 600m (someday).  I do little HF 
operating and single antenna connection is fine (external coax switch 
used for antenna selection).

I have an "old" Drake MN-2000 2kW rated manual tuner which handles my 
HF uses (do not chase HF-DX or HF-contest).

73, Ed - KL7UW
http://www.kl7uw.com
     "Kits made by KL7UW"
Dubus Mag business:
     dubususa at gmail.com