[Elecraft] ERR TXG in 5W calibration mode

[Julius Fazekas n2wn via Elecraft]

Just now updating an older K3 with 5.14 using an old winXP machine. The 50W
cal went as expected, the 5w cal gives me an error message: ERR TXG.
starting on 160. During calibration it only reaches 3.3W at 1.1:1 SWR. I can
go an adjust to 5w and it reads 1.0:1 when using a manual key. Tried the
calibration again at this point and it made it through 160 and hung on 3.750
MHz, same readings and issue.

I can set the rig and run CW fine @ 5w. calibration doesn't work. Haven't
tried going back to the old firmware, but see not reason the new FW
shouldn't work. Any suggestions?

Thanks,
Julius
n2wn



-----
Julius Fazekas
N2WN

Tennessee Contest Group
http://www.k4ro.net/tcg/index.html

Tennessee QSO Party
http://www.tnqp.org/

Elecraft K2        #4455
Elecraft K3/100 #366
Elecraft K3/100 
--
View this message in context: http://elecraft.365791.n2.nabble.com/ERR-TXG-in-5W-calibration-mode-tp7603793.html
Sent from the Elecraft mailing list archive at Nabble.com.