[Elecraft] Problem with Test TX Data and ALC

[Carl Jón Denbow]

<<<Which digital mode did you select? >>>

JT9

<<<Are you using mike input or line in input? >>>

Line

<<<If line in, have you adjusted the K3 line in level. >>>

I guess I need instructions about how to do this.  Please see earlier 
post I made about my inability to find proper menu item.

<<<Make sure you have selected the correct audio input source in the K3 
menu. >>>

Perhaps I need instruction about this too, though I set MIC+LIN to ON.

If using mike input are you using VOX or PTT?

Using PTT via CAT and K3 does key OK, just no audio seems to be TX.

73,

Carl
N8VZ
> brian <mailto:alsopb at nc.rr.com>
> Thursday, June 4, 2015 3:37 PM
> Hi Carl,
> Which digital mode did you select?
>
> Are you using mike input or line in input?
> If line in, have you adjusted the K3 line in level.
>
> Make sure you have selected the correct audio input source in the K3 
> menu.
>
> If using mike input are you using VOX or PTT?
>
> Is the K3 going into transmit?
>
> 73 de Brian/K3KO
>
>
>
> Carl Jón Denbow <mailto:carl at n8vz.com>
> Thursday, June 4, 2015 3:27 PM
> I've been trying to set up my data modes using a SignaLink USB, which 
> I've used with good results with my KX3, with my K3.  I do have the 
> correct K3 jumper board in the SL.  I also have the SignaLink supplied 
> cables hooked up correctly.  I can monitor digital signals just fine.  
> I can not get any TX audio actually transmitted, though Windows 
> indicates that the USB Codec Speaker is getting plenty of audio on 
> TX.  I've tried to use the Test TX DATA routine within the K3 and get 
> no ALC even when Windows indicates that that line has full bore 
> audio.  I'm probably doing something rather simple wrong here, but I 
> can't for the life of me figure out what it might be.  In terms of 
> experience, I'm an old hand at digital modes having run them on 
> numerous rigs, with various computers and external sound card 
> combinations over a number of years.  I'm, however, very new to the K3 
> as I just purchased it used at Dayton this year, and I'm just now 
> trying to hook it up for digital modes.  Thanks for any help you can 
> give.  73 de Carl, N8VZ
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to carl at n8vz.com

-- 
=================================================
Carl Jón Denbow, N8VZ
17 Coventry Lane
Athens, Ohio 45701-3718

carl at n8vz.com
www.n8vz.com
EM89wh

IRLP 4533   Echolink 116070

PSK and JT65 Forever!
=================================================