[Elecraft] [K2] EEPROM Problem?

[Joseph Baxley via Elecraft]

Hey!

I have an Elecraft K2, serial number 7535, with the following options
installed: KSB2, KNB2, KIO2, KAT2, KBT2, and K160RX.  I just installed the
K160RX board tonight after sitting on the kit for about a year and finally
set out to build it today.  Once I installed it I did the basic checks and
it is receiving on 160m and the board appears to work just fine.  The
problem is that I noticed that the rig now doesn't always remember it's
prior state if I power cycle it.  Previously, if I turned my K2 on, changed
frequency with the VFO knob, turned it off and turned it back on, it would
remember the frequency I had set it to.  Now it reverts to the frequency it
held when I last turned it on unless I do something like change the
operating mode at the new frequency.  In that case, it remembers the
frequency where I changed modes when I power-cycle the rig.  I do not
remember this behavior prior to installing the K160RX.  

Everything else about the rig seems to be working fine and the 160m board
seems to be working well.  I can receive, transmit, and use the receive
antenna.  

My question is: Is this an EEPROM problem, and if so, what is a likely cause
and how do I address it?  

Sincerely,

Joseph, KI4ITG



--
View this message in context: http://elecraft.365791.n2.nabble.com/K2-EEPROM-Problem-tp7603680.html
Sent from the Elecraft mailing list archive at Nabble.com.