[Elecraft] DigiKeyer II Connections to K3

[Joe Subich, W4TV]

> Must I have the Accessory connection on the cable connected to the
> Accessory jack?

The Accessory connection is used for FSK and PTT.  You need it
connected for PTT.

Does fldigi transmit in RTTY (AFSK) or any other mode (MFSK, Olivia,
etc.)?

Where is the slider for "fldigi/Hamlib K3/KX3" set in the Windows
Volume Mixer (Headset Earphone)?  Where is the Master (Headset
Earphone) slider set?

Is Configure | Sound Card in fldigi set to "Port Audio" and Playback
set to Headset earphone (microHAM CODEC)?

Where is the TX Level pot set on the front of DK II?

Can you transmit if you connect a 3.5mm to 3.5 mm cable between
the output of another sound card and the Line In of the K3?  I
have known L4 and/or L5 on the KIO3 Audio I/O board to fail open.

73,

   ... Joe, W4TV


On 2015-07-31 8:54 PM, pastormg wrote:
> Joe,
> Yes I have the correct settings for the Mic Line. The K3 goes from receive
> to transmit, but there is no power or ALC. And even if I turn the microphone
> gain to 60 nothing happens. Must I have the Accessory connection on the
> cable connected to the Accessory jack? I have been told by some that the
> line in should be connected to line out and the line out jack should be
> connected to line in. I even tried that and of course I cannot see any
> signals on the waterfall! Mark Griffin, KB3Z
>
>
>
> --
> View this message in context: http://elecraft.365791.n2.nabble.com/DigiKeyer-II-Connections-to-K3-tp7605632p7605637.html
> Sent from the Elecraft mailing list archive at Nabble.com.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to lists at subich.com
>