[Elecraft] K2 rework eliminators - mic board

[Don Wilhelm]

Unless you have a variety of microphones from various transceiver 
manufacturers *and* like to swap microphones often, I don't see much 
sense in the IMA.  Just wire the K2 microphone jack for the Elecraft 
configuration and re-wire the microphone plugs for that pinout.

OTOH, if you still have transceivers that use those microphones and 
cannot easily re-wire the mic plugs, then the IMA makes sense if you 
want to swap the mics around.
Most hams pick one microphone and use it with the K2, so there is 
normally no need to swap the IMA connections - just wire the normal K2 
microphone configuration for the chosen microphone.

On 7/26/2015 11:23 AM, Gary Marklund wrote:
> Floyd,
>
> I just did some snooping around their site and found this under "contact
> us",  http://www.unpcbs.com/us/#contact.
>
> Hope you find one. I built my K2 with both the unpcbs Rework Eliminator and
> the IMA. Makes life a lot easier.
>
>