[Elecraft] saving 2 TX EQ settings

[Bob]

Hi,

     That surely is a solution.  I have a desk mic, Kenwood MC60 and use via 
extension cables either a Yamaha CM500 or Heil to the rear Jacks when I want to 
use  a headset boom mic. it is a FP to rear panel switch.

      However, I have always thought that all the parameters for that change 
should be stored so the change is seamless. Gain, bias, EQ, compression etc,  Be 
pretty much set and forget.

      I'll confess to not knowing all involved in doing it  but to the Elecraft 
staff that knows, this is a HINT that may possibly be added to the list.

73,
Bob
K2TK  ex KN2TKR (1956) & K2TKR



On 7/21/2015 1:03 PM, Don Wilhelm wrote:
> Todd,
>
> You would have to write a couple macros.
>
> 73,
> Don W3FPR
>
> On 7/21/2015 12:56 PM, todd ruby wrote:
>> I have 2 very different microphones each of which would need its own TX EQ 
>> settings that would be very different. Is it possible to save each of them 
>> and be able to “toggle” back and forth between the settings if I changed mics?
>>
>>
>