[Elecraft] Paartially Assembled K2 in Limbo

[Don Wilhelm]

Louis,

Contact Elecraft (parts at elecraft.com) and ask if you can obtain the bags 
of parts for the K2 RF Board.
Unless you have a goodly stock of resistors and capacitors, that is 
likely to be the less expensive that ordering the parts one at a time.
The only caution I can give is that some parts have changed recently, so 
download the latest manual and errata and build the RF Board from that - 
do not ignore the errata, mark up the manual with the changes.

73,
Don W3FPR

On 7/20/2015 4:08 PM, Louis C LaCour Jr wrote:
> Hello All:
>
> I started to build a K2 a ways back, and since then have lost some of the packs of components (e.g. The resistors listed on p.48, Assembly Part II.
>
> I have completed the build up through and including Part I, but now I don't know that I can finish it. Can the basic components be re-ordered? Or perhaps I should just sell it as-is to to someone for parts. The front panel and control board are finished and test out fine.
>