[Elecraft] K2 Alignment

[Matt Maguire]

It is a bit on the low side, but may still be ok. Where the limited range could become a problem is in the filter alignment stage. You could try continuing and see how it goes; if the restricted range prevents you from aligning the filters properly, then some attention to the BFO circuitry may be required.

73, Matt VK2RQ




On Sat, Jul 11, 2015 at 10:48 AM -0700, "Tom Field" <docwatt at gmail.com> wrote:










I've been using my K2/100 for a couple of years, and have been very
satisfied. I have noted some drift in the freq, so decided to go through a
complete realignment process.

On Page 65 of the manual it describes a measurement of the BFO range as
being 4-6 kHz. I measure 3.52 kHz. Question one, is this sufficiently out
to be of concern? and question 2, what are the next steps to correct any
problem?

Tom
KN6DR
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to matt.vk2rq at gmail.com