[Elecraft] Microphone Qusestion

[Bob McGraw - K4TAX]

Thanks Jim.

Connectors and cable is no issue for me.   I use Neutric connectors and 
Mogami 3 conductor shielded cable.  I'll make up something as needed for 
the XLR to 8 pin connector depending on the mike I settle with.  I've a 
few pro dynamics in my recording studio collection.

Thanks for the suggestions, I always appreciate yours.  I'll be sure and 
follow those.

73 Bob, K4TAX

On 7/5/2015 11:49 AM, Jim Brown wrote:
> On Sun,7/5/2015 7:06 AM, Joe Subich, W4TV wrote:
>> The Heil PR-781 is grossly overpriced. Any quality dynamic mic will
>> work very well with the K3/K3S. 
>
> Right on both counts. Because I'm retired from pro audio, I have a 
> closet full of pro mics. All of the dynamic mics work very well with 
> the K3. Before one of the guys in our club introduced me to the CM500, 
> I used an RE11 on a boom stand from my music recording stash. I also 
> own two Sony MDR7506 headsets, which I no longer use in the shack 
> because the CM500 is so good.
>
> The TX EQ built into the K3 is quite capable, and is all that is 
> needed to tailor TX audio to a mic and a voice. An external equalizer 
> is a waste of money. All it takes to use any dynamic mic with a K3 or 
> K3S is a suitably wired connector or connector adapter cable. For a 
> pro mic with an XL-connector, wire pin 2 to the mic input, pin 3 to 
> mic return, and pin 1 to the connector shell. Or if you have a two 
> wire cable (center plus shield), wire pin 2 to the center conductor 
> and to mic input, tie 1 and 3 together to the shield, and connect to 
> the K3 connector shell.
>
> 73, Jim K9YC
>
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to rmcgraw at blomand.net
>
>
>