[Elecraft] KRC2 relay control

[Byron Servies]

Hi,

See the KRC2 manual and search for AC1.  On Page 15 of the rev.C
manual, the KRC2 test procedure includes using F4 for accessory
drivers, and page 19 has the default behavior of F4.

I am not in front of my ham pc right now, but I believe there is a way
to trigger those from the utility. Perhaps someone else knows if there
is a command in the K2 programmers manual for triggering these
outputs.

73, Byron N6NUL

On Sat, Jul 4, 2015 at 10:24 AM, Rich <rwnewbould at comcast.net> wrote:
> I have research this idea on my own and do not see a way to do what I want.
> I know there are really smart folks on this list so I am looking for some
> help.
>
> I was hoping to control the 12vdc (ON/OFF) for my RX ant preamp via the K3
> keyboard commands (Writelog, N1MM).  I was thinking this could possibly be
> done via the sink/source relays in the KRC2.   I already use the KRC2 for
> band decoding,  but it appears to me that the relays only react to band
> changes.  Are there  computer controllable commands for the A B C D relays
> in the KRC2 or any other ideas?
>
> I hope this is clearer than mud.
>
> Rich
> K3RWN
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to byron at n6nul.org



-- 
- Northern California Contest Club
- CU in the Cal QSO Party 3-4 Oct 2015
- www.cqp.org