[Elecraft] PX3 with "other" I/Q Receiver?

[Peter Eijlander (PA0PJE)]

I did, it works....

With a Softrock-RX for 30 metres. The LO is an xtal on 40.5 MHz that 
produces 10.125 MHz and that shows on the PX3 as 0Hz.
The real problem comes with the need to recalibrate te I/Q phase and 
amplitude in order to have a good image rejection.
On -25 kHz I see the DDK9 teleprinter and on +20 kHz I see the average 
bunch of data modes and in between: CW sigs.
For me it was merely "try and see what happens" for the KX3 obviously 
rocks much better...

73,
Peter - PA0PJE

Op 2015-01-27 23:52 schreef Tom Blahovici:
> Hi
> It would not work properly as is. I think one would need to send information to the px3 via the serial port to establish the centre frequency,  markers, and respond to qsy''s.etc. as well as react to requests coming from the px3.
> Assuming these are standard api type  commands it could be a possibility. Could be a fun project.
> Tom
> va2fsq.com