[Elecraft] K1 LCD and Error code

[Richard Swanson]

I am building a K1.  On page 37, Alignment and test, Part 1, when I turn 
on power I do not get the e27 display.  The LED test was correct.  The 
LCD only shows a few vertical bars on the top half of the display.  If I 
tap a switch, the display goes blank.  All resistance and voltage checks 
up to this point are OK.  I have gone back over the construction steps 
and check soldering etc.  Can't find anything wrong.  Any suggestions?

---
This email is free from viruses and malware because avast! Antivirus protection is active.
http://www.avast.com