[Elecraft] Working Split with a K1

[Michael Babineau]

Brian :

That is a very good point .. on the K1 both RIT and XIT both use the same offset control.
So once the offset is set .. then toggling between XIT and RIT will allow you to 
listen to your TX frequency.  Brilliant. 

Thanks for sharing .. this is very useful … I will try this next time, now that I have finally managed to
figure out how to re-enable XIT ;-) 

Michael VE3WMB / VA2NB 

>From: Brian Hunt <huntinhmb at coastside.net>
>Subject: Re: [Elecraft] Working Split with a K1
>Date: January 18, 2015 at 12:19:54 PM EST
>To: "elecraft at mailman.qth.net" <elecraft at mailman.qth.net>


>A while back I found a writeup that Wayne did on using the K1 RIT/XIT. It mimics the A/B switching of two VFOs. 

>1. With RIT & XIT off, tune in the DX station. 

>2. Tap RIT and using the RIT knob, tune to a clear spot in the pileup. 

>3. Hold XIT. 

>Now you are listening to the DX and transmitting in your clear spot - just like a A/B VFO swap. 

>Slick!

>72,
>Brian, K0DTJ