[Elecraft] KXPA100 Loosing Communications/ Turns PA Mode Off

[Wayne Burdick]

This was fixed in KX3 MCU rev. 2.28. I'll send you the latest (2.33).

73,
Wayne
N6KR

On Jan 16, 2015, at 10:59 AM, Irwin Darack <idarack at gmail.com> wrote:

> I recently checked and upgraded all of the Firmware with my KX3 (MCU =
> 2.27, & DSP = 1.3), KXPA (1.32) and PX3 (1.16) that was older.
> 
> I found that  it lost communications from the KX3 to the KXPA100. Hence it
> results in turning PA Mode Off. Even when I go back into the Menu settings,
> turn PA Mode on again, It results in turning PA Mode back off again.
> 
> Even though I had full communications between the KX3 and KXPA100, to
> resolve the problem, I had to going into the utility program for the PX3,
> making sure it was communication with my computer, which it was, then
> update the KX3 Menu PA Mode to on.
> 
> I am not sure where the glitch is occurring. I have the standard cable set
> up as in the PX3 Manual and all data rates are set to 38400 baud. It seems
> to be related to the PX3.
> 
> Is there a way to extend the time out for the KXPA100?
> 
> Thanks, Irwin
> 
> -- 
> Irwin KD3TB
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to n6kr at elecraft.com