[Elecraft] [K3] NaP3 / CW Skimmer integration using only K3 as RX
Arie Kleingeld PA3A
pa3a at xs4all.nl
Fri Jan 16 04:23:58 EST 2015
John,
My standard setup here is:
Software:
- CWskimmer
- NAP3
- N1MM logger
- a simple piece of software called ' clusterjoin'
- LP Bridge
- systems: Win XP (until last month) and Win Vista (present time)
Hardware:
- K3
- Softrock -IF
- 6 yr old pc with 192kHz soundcard
Way of operation:
- All software is connected to the K3 via LPbridge
- N1MM is connected to 'clusterjoin' in the telnet window
- Spots of CW skimmer and an internet DXcluster are combined through '
clusterjoin' (commands to accomplish this are given via the telnet
window of N1MM logger) , all spots show up in the bandmap op N1MM logger.
Everything works together just fine. Thanks to all programmers of the
software that make this possible.
If you have any questions, just contact me.
73
Arie PA3A
John Shadle schreef op 14-1-2015 om 19:32:
> Hi all,
> I know that I have seen a blog post by a non-US ham about doing this, but I
> can't seem to locate concrete instructions on his site or elsewhere.
>
> My setup is as follows.
> - K3
> - LP-Bridge to share serial ports for rig control and logging
> - LP-PAN using NaP3
> - E-MU 0202 USB sound card
>
> NaP3 works fine with this setup, but I can't get CW Skimmer to load while
> NaP3 is running. Once I shut down NaP3, I can run CW Skimmer with no issues.
>
> Anyone have tips on how to use both NaP3 as well as CW Skimmer
> simultaneously with this setup?
>
> Thanks!
> -john W4PAH
> Madison, WI
More information about the Elecraft
mailing list