[Elecraft] Help - K3/100 no power over 12w

[Matt Zilmer]

1. Make sure CONFIG:KPA3 shows 'PA nor'.  If not, set it to 'PA nor'.

2. If 1. doesn't work or doesn't apply, contact
K3support at elecraft.com.

73,
matt
W6NIA

On Tue, 13 Jan 2015 10:59:19 -0500, you wrote:

>Prior to running WSPR on 10 meters at 5 watts for about 30 minutes
>yesterday the radio was functioning properly putting around 30 watts into a
>KPA500. Now today nothing above 12. I've tried the parameter
>initialization, power calibration, and even reloading the firmware but no
>joy. Is there anything else I could try or should I ship it to Elecraft?
>Thanks, Reed AA1RB
>______________________________________________________________
>Elecraft mailing list
>Home: http://mailman.qth.net/mailman/listinfo/elecraft
>Help: http://mailman.qth.net/mmfaq.htm
>Post: mailto:Elecraft at mailman.qth.net
>
>This list hosted by: http://www.qsl.net
>Please help support this email list: http://www.qsl.net/donate.html
>Message delivered to mzilmer at roadrunner.com
Matt Zilmer, W6NIA
--
"Give me six hours to chop down a tree and I will
spend the first four sharpening the axe." -A. Lincoln