[Elecraft] [KX3] MCU 2.27 BUG NB/NR mode

David Anderson gm4jjj at yahoo.co.uk
Sat Jan 3 13:40:33 EST 2015


Thanks for clarifying that. It's not something that had bothered me, but I just observed it after Nakamura asked the question about the behaviour of the VFO with NB/NR. I had thought at first he meant it stopped the VFO completely, not just a short pause while displaying the parameters - which I am sure there are technical reasons for.

73

David Anderson GM4JJJ 

> On 3 Jan 2015, at 18:29, Wayne Burdick <n6kr at elecraft.com> wrote:
> 
> When you're displaying noise blanker or or noise reduction parameters, etc., the VFO is disabled.
> 
> Wayne
> N6KR
> 
> ----
> http://www.elecraft.com
> 
>> On Jan 3, 2015, at 1:11 AM, David Anderson <gm4jjj at yahoo.co.uk> wrote:
>> 
>> I observe this pause too. The main VFO does not move while the NR or NB setting display is showing. I am not sure if this was always like this or not.
>> 
>> Perhaps someone with an earlier version of firmware would like to check and comment?
>> 
>> 73
>> 
>> David Anderson GM4JJJ 
>> 
>>> On 2 Jan 2015, at 08:07, JE0LFI <anchor at chorus.ocn.ne.jp> wrote:
>>> 
>>> Hi all, Happy New Year 2015!
>>> 
>>> In version 2.27, when you turn on the NR or NB of KX3, will not move the
>>> main dial.
>>> 
>>> Is this a specification, or bug of v2.27?
>>> 
>>> ---
>>> 
>>> JE0LFI / Nakamura
>>> 
>>> 
>>> 


More information about the Elecraft mailing list