[Elecraft] Heil Classic

[Jim Brown]

On Thu,1/1/2015 9:17 AM, David Ahrendts wrote:
> I’m sure it is possible.

Yes. The K3 and KX3 work very well with virtually any decent mic. All 
that is needed is a properly wired connector adapter. Just pull out the 
documentation for the mic and the K3, see what pins are connected to the 
mic on each end, dig out the connectors, pull out your soldering iron, 
and make the adapter. I buy ham mic connectors at ham flea markets and 
keep a few in the junk box. I buy audio connectors from Full Compass 
(near Madison, WI).

If I had to adapt from an RJ45, I would buy a pre-made cable with the 
RJ45 connector, cut off the other end, and install the mic connector for 
the radio.

73, Jim K9YC