[Elecraft] K3 - What settings to use for RX and TX Audio

[Matt Murphy]

If you want ragchew audio it probably makes sense to:

- turn the preamp off
- use slow AGC
- use as wide a passband as band conditions permit (phone) and about 800Hz
on CW
- in the receive EQ perhaps reduce band 7 and 8 a bit to remove some of the
highest pitched sounds/noise
- listen through a larger speaker to add a bit more resonance than the
built-in speaker can provide.



- For TX you can listen on the monitor using headphones and fine tune it to
be exactly how you want. I think K9YC had some recommended presets for TX
EQ for contest audio.

73,
Matt NQ6N

On Thu, Feb 26, 2015 at 3:04 PM, Bill <w2blc at nycap.rr.com> wrote:

> Take a look at:   http://www.w2blc.net/K3.htm
>
> Just be forewarned - these are settings I use and other users may not like
> them.
>
> Bill W2BLC K-Line
>
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to matt at nq6n.com
>