[Elecraft] K3_KSYN3A_Synthesizer

[Dave Olean]

I just built a K3 (#8858) with the new synthesizer, and did the milliwatt 
calibration without a hitch. I set it for 1.5 mw max output, but possibly 
you did not crank the power up high enough when you started. I made that 
mistake reading the power level and got low output.  I used a power meter 
and am seeing 1.0 Milliwatt out on three transverter bands with the K3 dial 
indicating 0 dBm.

Dave K1WHS
----- Original Message ----- 
From: "Ken Roberson via Elecraft" <elecraft at mailman.qth.net>
To: "Elecraft Reflector" <elecraft at mailman.qth.net>
Sent: Wednesday, February 25, 2015 11:00 PM
Subject: [Elecraft] K3_KSYN3A_Synthesizer


> Anyone else having trouble with milliwatt TX gain Cal using the new 
> synthesizer boardOr is it just me.Also on the RF power out only one bar is 
> lite up.If I set power to 0 dbm (1 milliwatt) it only shows -12.0 dbm ( 
> .06 mw)
> Thanks
> Ken K5DNL/WG2XXM
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to k1whs at metrocast.net