[Elecraft] Sherwood Engineering Tests

[Rob S. via Elecraft]

Wayne,

Will other radios that have the revised synthesizer board upgraded in the field need to perform the receive gain calibration in order to correct the AGC threshold issue as well?

 Is this something that will change upon installing the new board?

73,

Rob

 KB2KUU




Sent: Tuesday, February 24, 2015 4:57:23 PM 
Subject: Re: [Elecraft] FW: Sherwood Engineering Tests

Just to complete the point about this: The K3 tested probably didn't have its S-meter calibration ("RX gain cal") completed before we sent it to Rob, an oversight on our part. This procedure is fully automated by the K3 Utility program, and definitely would have corrected the sensitivity threshold issue Rob observed.

73, 
Wayne 
N6KR