[Elecraft] K3 no SSB receive

[Bruce Meier]

The NO SSB audio also happened to me on one of my K3s.  All other modes were
fine but and after a few minutes of experimenting I found out that I could
get SSB RX but only by opening up the Width beyond the 2.7kHz first filter.
As soon as the width was at or below 2.7 the audio was gone.   I also
checked to see if I could open up other modes - NO.  The width setting would
not go beyond my second filter which is set to kick in / out at 500 hz.
So, I did a "RESTORE CONFIGURATION" from the one that I saved just after
loading the new 5.1 firmware.   That seems to have fixed it.  Not sure why -
but it is working.   My other K3 is running the same 5.1 firmware and has
not had the problem.

 

Something must have changed, but to my knowledge, I did not do anything.

 

73,

Bruce - N1LN