[Elecraft] Lost sub receiver in right headphone

Jerry Knowlton w1ie at jetbroadband.com
Sun Feb 22 17:04:17 EST 2015


Hello,

Does anyone have any suggestions on troubleshooting (config or Main or
"buttons") menus for this problem. 

When I plug in the headphones, there is no audio from the sub receiver (sub
has been selected), however, pulling the headphones jack out 1/8 of an inch
I receive both Main and Sub in both sides of the headphones. When I remove
(deselect sub) there still is no audio on the right ear. I loaded the new
firmware, but I am not sure if I lost the "right" ear audio before or after
the firmware update. I have reversed the firmware update and got the dual PB
back.

An email has gone out to Elecraft Support with essentially the same info.

Best regards,

Jerry ,W1IE


-----Original Message-----
From: Elecraft [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Hank P
Sent: Sunday, February 22, 2015 2:40 PM
To: Elecraft
Subject: Re: [Elecraft] K3 no SSB receive

On any band   CW/DATA/AM receive normal  both main and sub dead on SSB 
either sideband. Can watch the P3 and signals obviously still coming out of
the IF but rx goes dead when MODE is tapped to USB . And I mean DEAD - not a
whisper phones or speaker RF and AF gain wide open. NB/NR on or off no
change.

Saw that W4BQF has same issue - but could not find any responses.

Hank K7HP


______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html Message
delivered to w1ie at jetbroadband.com



More information about the Elecraft mailing list