[Elecraft] KSYN3A Install Doc Suggestion

[Phil Wheeler]

Best part was NOT having to reinstall those split 
washers :-)

Phil W7OX

On 2/20/15 7:04 PM, Gary Ferdinand wrote:
> I’m a very satisfied K3 owner.  Today I installed the two KSYN3A boards according to the documentation.   My K3 has the internal 2 meter transverter (K144XV) installed, so I had a few extra steps to perform above a 2-board, no transverter configuration.
>
> I got hung up a few minutes on page 14.  A couple of extra sentences would have eliminated the extra time spent at this step.
>
> I suggest the instructions also state that the cable that used to be run from the K144XV from the REF OUT jack be reused between KREF3 J2 and MAIN KSYN3A J83.  The cable supplied with the kit is an 8.5” cable and the diagram, figure 12, shows a 5” cable here.  Not that the cable length matters much, but the lack of clarity of this point had me wondering if I had missed something involving the “extra” cable.  Further stating that I would end up with an unused 8.5” cable would also have helped.
>
> Additionally, in Figure 12 the MAIN board is mislabeled as KSYN3 instead of KSYN3A.
>
> All in all a smooth installation. Thanks for the improvements!
>
> 73/Gary W2CS