[Elecraft] [K2] 8T signal at J13

[Don Wilhelm]

Steve,

As far as I can determine, no harm would come from making that connection.
IMHO, it would be better to invert the 8R signal, but then I did not 
have any 'say' in the DEMI design.

73,
Don W3FPR

On 2/10/2015 4:07 PM, Steve Kavanagh wrote:
> I was given a DEMI TIK2 transverter interface board which I would like to install in a K2.  It requires the 8T signal on pin 6 of J13 on the RF board, which was there on early K2s but not on more recent versions.  Can I just connect together the pads marked "X" and "8T" (on page 9 of the K60XV manual for example) ?  Or will this make weird things happen?  Obviously I'd have to break this connection if I wanted to swap in a K60XV instead. 73,Steve VE3SMA
>