[Elecraft] K2 Build: Voltmeter Probe Assembly help

[Mick Hall]

Hi

I have been progressing through the tests on my K2 build (7587), and have assembled the voltmeter probe as per instructions on page 44 of the manual, and engaged the crimp pin in the upper part of the housing as per the diagram.

When I touch the tinned end of the wire on pin 1 of the I/O controller, U1 on the RF board, I get a reading of zero volts on the K2 LCD. It is meant to be 6V approx.

I have tested with my DMM that their are no breaks in the probe. All other tests, before and after, have been fine up to the start of Assembly Part II .

Is this anything to worry about?

Best Regards
Mick