[Elecraft] PF1 and PF2 Programming Question

[Michael Eberle]

Absolutely.  Go into the K3 Utility on the Command Tester/K3 Macros 
tab.  Click the 'Edit Macros' button.  Type a label for the macro in the 
Macro Label field.  In the Macro Commands, use the command TE followed 
by a numerical value for each EQ setting (i.e. 50, 100, 200, 
400...etc).  For example, TE-12-10-06-02+00+06+08+10;

This will set 50 Hz to -12db, 100 Hz to -10db, 200 Hz to -06db... etc.  
Don't forget to enter the ; at the end.  Save your macros and then send 
them to the K3 using the 'Write Macros 1-8 to K3' button.  Then go into 
the K3 CONFIG menu and select 'MACRO 1' with the VFO B knob.  Then hold 
PF1 down for a second or two and it will assign macro 1 to PF1.  Then 
press 2 on the keypad to switch to MACRO 2.  Hold PF2 and it will assign 
macro 2 to PF2.

If you want, you can also specify mic gain and compression settings 
along with the TX EQ commands.  MG014; will set mic gain to 14 and CP12; 
will set compression to 12.  You enter it in the macro command with the 
EQ settings as follows: MG014;CP012;TE-12-10...+08+10;

73
Mike - KI0HA



On 2/5/2015 04:27, Mike VE3YF wrote:
> Hi:
>
> I haven't tried my hand at doing some programming yet, but wondering 
> if it is possible to set the PF1 and PF2 for TX EQ Audio settings.
>
> I would like to set PF1 for one set of TX EQ Settings (Working DX) and 
> set PF2 for another set of TX EQ Settings (Ragchew). This way I
> can alternate between PF1 and PF2 for my desired settings instead of 
> manually changing the TX Equalizer.
>