[Elecraft] P3 beta software - Span Step NOT "sticky"

[Paul Saffren N6HZ]

I just checked on a newly upgraded P3/SVGA and stepped span is remembered
through a power cycle. (I also checked the code just to be sure).  If I turn
on stepped span and then power cycle the unit and press the SPAN key, the
span is in stepped mode.  If I press a key that I assigned to stepped span,
it shows "OFF" when I press it, which means it was previously on. 

The P3 (and PX3) save values to non-volatile memory when the data is
changed. In other words while you are adjusting it and not when the power
switch is pressed, so it doesn't matter if you pull the plug or push the
button to power it off. 

-Paul






--
View this message in context: http://elecraft.365791.n2.nabble.com/P3-beta-software-Span-Step-NOT-sticky-tp7597820p7597829.html
Sent from the Elecraft mailing list archive at Nabble.com.