[Elecraft] K3 Odd behavior

[Mike Reublin NF4L]

A TX cal seems to have taken care of the power issue.

Mike NF4L

> On Feb 2, 2015, at 8:09 AM, Mike Reublin NF4L <nf4l at comcast.net> wrote:
> 
> I did a poor job on describing the noise level jump. If I switch to ANT2, the 2nd rec. level goes WAAAY up.
> 
> 73, Mike NF4L
> 
>> On Feb 2, 2015, at 7:38 AM, Mike Reublin NF4L <nf4l at comcast.net> wrote:
>> 
>> This morning I noticed something strange with #3539. On 80 & 160, tune only put out 10W. The level is set for 44W. Full output is 44W, power set to 100W. SWR with the AT in bypass is 1.3 on 80M, 1.2 on 160M. All this on ANT1. Power out on 40M & up is as expected.
>> 
>> I connected a dummy load to ANT2, and while screwing the connector on, there was a huge jump in the volume level on the 2nd receiver. The selected antenna is still ANT1. This condition is for all bands. The main receiver performs as expected, when ANT2  is selected, noise goes down.  
>> 
>> 73, Mike NF4L
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>> 
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>> Message delivered to nf4l at comcast.net
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to nf4l at comcast.net