[Elecraft] KX3 SWR indicator

[Dana Browne]

The firmware is up to date (MCU 2.34, DSP 1.33).

I have done a TX gain calibration and the SWR indicator is still reading 
as before.

Dana Browne, AD5VC

On 12/27/2015 7:15 PM, Walter Underwood wrote:
> What version of firmware are you running?
>
> I’d update the firmware and run a TX gain calibration with the KX3 Utility.
>
> wunder
> K6WRU
> Walter Underwood
> CM87wj
> http://observer.wunderwood.org/ (my blog)
>
>> On Dec 27, 2015, at 5:10 PM, Dana Browne via Elecraft <elecraft at mailman.qth.net> wrote:
>>
>> Oops, pressed enter too soon.
>>
>> I neglected to mention that the only additional board I have in the KX3 is the antenna tuner, I do not keep batteries in it, and the serial number is #150, so a rather early model.  I was unable to find anything in the KX3 manual about the SWR meter, but I recall seeing something posted on the reflector about it being pretty reliable.
>>
>> --
>> Dana Browne, AD5VC
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>>
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>> Message delivered to wunder at wunderwood.org
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to ad5vc at yahoo.com
>