[Elecraft] P3 Config Question

[Ferris Jennings]

Hi again -

 

I'm configuring my new P3, and have one big question: is there a way to make
"global changes".

 

To expand:

.         I set up 20 meters to show S units (LvL Mode=S Units); a Ref Lvl
from S0 to S9; Average = 5; Span = 20 khz, and apply that all to FN1

.         I then set up 20 meters to show S units (LvL Mode=S Units); a Ref
Lvl from S0 to S9; Average = 5; Span = 100 khz, and apply that all to FN2

 

That all works perfectly, and toggles between FN1 and FN2 is great.

 

But, when I go to any other band: 

.         FN1 and FN2 toggle correctly between 20 khz and 100 khz, the
screen still displays S units; and the Average remains at 5.

.         But, on all bands except 20, where I configured the P3 , Ref Lvl
is way off, with S5 displayed at the bottom with +30 at the top of the
screen.

 

Desired State: What I would like is for the P3 display to appear the same on
all bands. So, is there a way to apply configuration changes globally to all
bands, or do I have to manually set Ref Lvl on each band?

 

Thanks

-Ferris NB6T-