[Elecraft] K3 sub RX off freq in SSB diversity mode

[Wayne Burdick]

Milt,

What firmware revision are you using? We made some changes in rev. 5.33 to allow for mixed crystal filter offsets in main/sub.

73,
Wayne
N6KR


On Dec 15, 2015, at 8:28 AM, "Milt -- N5IA" <n5ia at zia-connection.com> wrote:

> Well, after following some suggested routines by various on and off list repliers, the problem still exists.
> 
> Very strange.  Any other suggestions before going to the big boys in HQs?
> 
> Milt, N5IA
> 
> 
> -----Original Message----- From: Milt -- N5IA
> Sent: Friday, December 11, 2015 12:18 PM
> To: elecraft
> Subject: [Elecraft] K3 sub RX off freq in SSB diversity mode
> 
> I normally don't have much to post here, but today I do have a question.
> 
> I discovered last night that I have the following situation.
> 
> When in SSB mode on 160 Meters and the 2nd RX is turned on, the SSB signals
> are on the same frequency.
> 
> When I invoke the diversity mode, the 2nd RX is receiving at 1.5 kHz higher.
> 
> I tested this on numerous signals and at various frequencies; always the
> same.
> 
> In the CW mode the problem does not exist.  In diversity mode the CW signals
> in both RXs are on the same frequency.
> 
> Anyone with an idea of what is happening here.  I do not remember this
> happening before.  RIT is off.
> 
> I did not try other bands as I normally do not operate on other bands.
> 
> I have searched the archives but have not gotten a hit on anything like
> this.
> 
> Any responses, direct or to the reflector would be appreciated.
> 
> Thanks in advance es 73 for now......
> 
> de Milt, N5IA