[Elecraft] K3 M1 Button Corrupt
Don Wilhelm
w3fpr at embarqmail.com
Sat Dec 12 15:10:50 EST 2015
Ron,
Hopefully you have a saved configuration file.
That sounds like a good reason to do an EEINIT and restore the
configuration file.
If you need info on how to do EEINIT, look in the manual under Parameter
Initialization n the Troubleshooting section.
If that does not correct it, contact support.
73,
Don W3FPR
On 12/12/2015 2:57 PM, Ron N9RC wrote:
> I was running K3 with HRD software and manually entered MENU. Not sure of
> the exact sequence but now the M1 button functions like the MENU button and
> returns to the last MENU setting I was looking at. Toggling again returns
> to NORMAL operation. This is via front panel button or software command. I
> have powered down and up and reloaded all K3 software. I suspect a hidden
> table with button actions that needs to be reset. Any ideas?
>
> Ron N9RC
>
More information about the Elecraft
mailing list