[Elecraft] Configuring the RRC remote rig box with the K3s

[Howard Sherer]

I had great success using the K30 with my K3 using the RRC boxes. I now
have a K3s and it is running great along with the P3, KPA etc using the
special CBLP3Y cable supplied for the P3. I have not yet tried to re wire
the RRC box to the K3s but I am not sure if I should disconnect the PC end
of that cable from the PC and plug on the P3 and connect it to the RRC com
port, or remove the CBLP3Y cable from the K3s and install the RJ45-DE9s
cable between the K3s and the RRC box?

Since I am currently using the USB for my com port interface, I would
assume that when using the RRC box, I would re configure the K3s for using
the regular RS 232 port xxx baud?

Has anyone on this list had experience with wiring up the K3s to the RRC
remote unit?

Howard AE3T