[Elecraft] SW TONE Config

[Dwayne Rohmer]

Doug,

It may be possible that the CW monitor volume was turned to zero. 
Setting the monitor volume in CW mode also sets the button feedback tone 
volume.

73,

Dwayne WV5I

On 8/23/2015 1:39 PM, Doug Wetzel wrote:
> Apologies if this has been covered before.
>
> My K3 button tone has decided to retire without warning.  Turning the
> config setting on and off has no effect.
>
> Tried hard reset, which works to re-enable the tone, but reloading the
> saved config kills it again.
>
> I know the end answer to this is likely to be, "Suck it up and manually
> reset all your configs after a hard reset, then save that config."
>
> Is there a magic incantation I can use to get this annoying little glitch
> solved before diving off that cliff?
>
> Thanks all!!!
>
> Doug
> K7IP
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to djcarohmer at ntin.net
>
>