[Elecraft] normal K3 voltage drop on TX

[Chester Alderman]

You should be sure to NEVER say that around a microwave person! As long as
you stay in HF, crimps may be OK. As a retired microwave circuit and systems
design engineer, there will never be a crimped anything in my ham station.
Saying 'crimped' is better than soldered is the same as saying you don't
know what you are talking about! Just my opinion of course.

73,
Tom - W4BQF



-----Original Message-----
From: Elecraft [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Jerry
Moore
Sent: Friday, August 21, 2015 9:38 PM
To: Bob McGraw - K4TAX; elecraft at mailman.qth.net
Subject: Re: [Elecraft] normal K3 voltage drop on TX

I respectfully disagree. A properly made crimp is superior to a soldered
connection. The key word being properly made. If you don't have the correct
tools to do a proper crimp then a good compromise is to solder the
connection after crimping, however, that's only to comply with connection
best practice to establish a good mechanical and electrical connection. A
proper crimp serves to mechanically weld the conductors together.
Jer, AE4PB
K3S TBA
 
 

his email list: http://www.qsl.net/donate.html Message delivered to
aldermant at windstream.net