[Elecraft] K3 Stuck in MCU LD

[Dick Dievendorff]

There is a recovery procedure in K3 Utility Help.  See Troubleshooting, MCU Load.  

73 de Dick, K6KR



> On Aug 21, 2015, at 00:37, pastormg2 at verizon.net wrote:
> 
> I am sending this message again, as it seems my first message never made it to the board. I was trying to load the new Firmware into my K3. Well for some reason we had a power blip during a storm and now my K3 is stuck in MCU LD. Right now the screen in dark when power is applied and MCU LD is on the screen. The Red TX light is flashing and after a period of time it will then go to the Delta F light which will flash yellow. I cannot connect to my K3 via my computer because I'm sure it's because it is stuck in the MCU LD error. How does one reset their K3. I read about the EE Init where I Held in the Shift/Lo button while pressing the Power button and nothing  Plus to get the K3 out of this state I need to shut off the power supply. Every button is totally useless. Perhaps I need to call the people at Elecraft once I get home from work this afternoon. Hopefully someone on the board will have a solution or someone from elecraft will see this message and help! Thanks! Mark Griff
> in, KB3Z
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to dick at elecraft.com