[Elecraft] KAT100 Tuning Failure

[Don Wilhelm]

It sounds to me like all should be well.

As a refinement ---
If you have 2 50 ohm dummy loads and a coax TEE adapter, you could put 
the dummy loads in parallel to produce a 25 ohm dummy load. That will 
give you a sanity check on the Reflected trimmer pot calibration - 
adjust it to light the SWR=2 LED.

Note that the power and SWR displayed on the K2 come from the KPA100 and 
not the KAT100.

73,
Don W3FPR

On 8/10/2015 6:14 PM, JeremyJones wrote:
> Ok,  I received the new diodes today and have installed them into the KAT100.
> Running the tests in CAL mode has the LED indicators on the KAT100 matching
> what the display on the K2 reads, as well as matching the W2 watt meter.  Is
> there anything else I should be looking at before starting to put things
> back together?
>