[Elecraft] Blank display on K3 power on

[Don Wilhelm]

Glenn,

Fire up K3 Utility and first read the HELP section on forcing a firmware 
load.  Follow those instructions and load all firmware.

If that does not work, contact K3support.

73,
Don W3FPR

On 8/9/2015 7:39 PM, Glenn - N5RN wrote:
> All -
>
> I turned on my K3 this afternoon and was greeted by a blank display.  
> I found that I couldn't turn the radio off using the front panel 
> button so I pulled the power.  After plugging the power back in, I 
> tried again.   A blank display.  Since I had a backup I opted to try a 
> reset (shift LO-power on) and the radio hangs at the EE INIT display.
>